Use the pin tool to slide the speed switch (positioned on the left side of the controller) fully down.
2.
Slide down the riding mode switch (positioned on the left side of the wireless controller) to 'ECO' mode.
3.
Make sure the 'BLUETOOTH' switch (ill. 4) is switched to the side closest to the motor, then turn on the board by switching the power switch on. The board should now beep two times and its battery status indicator should be flashing fast.
4.
Begin with the 'BLUETOOTH' switch flipped toward the right (closest to the motor). Immediately after powering the board ON, move the ‘BLUETOOTH’ switch to the left (furthest away from the motor) and back to the right (closest to the motor). Then the battery status indicator should go from flashing fast to flashing more slowly.
5.
Slide down the wireless controller’s throttle / brake to the lowest possible position, and hold it there.
At the same time, press and release the start button while the throttle/brake is still held down.
After 7 seconds, the controller will show 8 green flashes, followed by blue flashes. At this point release the throttle / brake. The board should now beep again, indicating a successful synchronization.
